Table of Contents
Advertisement
Type 2
Memory module
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get
damaged.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 43.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 44.
Removal procedure
Note: A Mylar film might cover the memory module. To access the memory module, peel off the film first. Do
not damage the mylar film and attach it in place after installation.
and print the following instructions.
Chapter 6
.
49
CRU replacement
Advertisement
Table of Contents
