Table of Contents
Advertisement
Note
• In some cases, "C-7" and "C-9" are displayed at the same time. In that case, refer to both items.
C-8
Too many clients are connected.
Wireless Direct does not allow more than 5 devices to be connected.
If you want to connect additional devices to the printer, unplug any devices that are not in use before
adding them.
C-9
The noise level is high and does not differ from the signal level due to various devices other than the
printer.
• If devices (microwave oven, external hard disk drive, and other USB 3.0 devices) that emit radio waves
of the same frequency bandwidth as a wireless router is nearby, it may cause interference. Place the
printer and the wireless router as far away from interference sources as possible.
• After you change the location of the printer, check the signal quality. Compare with the value of "3-2-2"
in the network settings information and place the printer in the location with a higher value.
Note
• In some cases, "C-7" and "C-9" are displayed at the same time. In that case, refer to both items.
C-10
No IP address is assigned by the wireless router.
Check the following items.
Password on your wireless router may not match password you entered.
Check 1
Passwords are case sensitive.
Enter the password correctly.
Set up printer again and reconnect to Wi-Fi.
Check 2
Check DHCP on wireless router. If DHCP is off, set it on.
Check 3
For details, refer to the wireless router's instruction manual.
C-11
The network name (SSID) remains the default value (The network name (SSID) has not been set). Check
the network name (SSID) of the wireless router.
Verify the network name (SSID) and password of the wireless router you want to connect to, and then set it
up manually.
Note
• Wi-Fi Connection Assistant allows you to diagnose and repair the network status.
•
Select the link below to download Wi-Fi Connection Assistant and install it.
449
Advertisement
Table of Contents
