Table of Contents
Advertisement
Print settings
Select this setting item from
• Prevent paper abrasion
•
Use this setting only if the print surface becomes smudged.
Important
• Be sure to set this back to OFF after printing since it may result in lower printing speed or lower
•
print quality.
• Amount of extension
•
Selects the amount of image that extends off the paper when printing in borderless (full).
When performing Borderless Printing, slight cropping may occur at the edges since the printed image is
enlarged to fill the whole page. You can change the width to be cropped from the borders of the original
image as needed.
Important
•
• Settings will become ineffective in the following situations:
Printing from a handwritten navigation sheet.
Printing from a standard form.
Note
•
• When performing settings from application software or the printer driver, these settings will be
prioritized.
•
• If printouts contain margins even though you are printing in Borderless, specifying Extended
amount: Large for this setting may help solve the problem.
•
• Adjust disc print area
You can adjust the disc printing area if the image is not aligned with the printable disc. You can adjust
the printing area in increments of 0.004 in. (0.1 mm) between -0.04 in. (-0.9 mm) and +0.04 in. (+0.9
mm).
• Auto photo fix settings
•
When ON is selected, the Exif information recorded in the images is given preference for printing.
•
• Adjust horizontal print position
Adjusts the print position when the left/right margins are not aligned.
You can adjust the left/right margins in increments of 0.004 in. (0.1 mm) between -0.12 in. (-3 mm) and
+0.12 in. (+3 mm) centered on the horizontal center of the paper.
Printer settings in
188
(Setup).
Advertisement
Table of Contents
