Pioneer SX-2900 Service Manual page 30

@2 BALANCE control
Shauld normally be left in the center position. Adjust balance if the sound
is louder from one of the speakers. If the right side is louder, turn toward
the L position and if the left side is louder, turn toward the R position.
@3) VOLUME control
Use to adjust volume level.
FM TUNING AUTO/MANUAL button
Works during FM reception.
Use this button to select either the AUTO mode or the MANUAL mode.
When the "AUTO" indicator is lit, the receiver is in the AUTO mode.
(5) DIRECT ACCESS tuning button
When this button is pressed, the STATION CALL buttons function as
ten-key number buttons for direct input of the desired reception
frequency. Press again to cancel this mode.
If the input station falls outside of the receiver's tuning range, the display
section will display a message: "UPPER" if the frequency is too high
and ''LOWER"' if it is too low.
(8) GRAPHIC EQUALIZER controls
The equalizer is divided into five frequency ranges (100 Hz, 330 Hz,
1 kHz, 3.3 kHz, 10 kHz) to tailor music to the individual taste of the
listener.
@) CUSTOM MEMORY buttons
Stations can be assigned to STATION CALL buttons according to the
genre of material broadcast (POP, ROCK, OTHER). You can recall a
particular genre, and scan all the stations of that genre with Memory
Scan until you reach the desired one.
=> Gr—t—] 2]
(8) OPERATION DISPLAY panel
(a) Indicates the function or frequency by the function switches.
(b} TUNED indicator
(c) FM STEREO indicator
(d) FM MONO indicator
{e) TUNING AUTO/MANUAL indicator
{f) DIRECT ACCESS tuning indicator
(g) CUSTOM MEMORY indicator
(j) MEMORY indicator
{k) TAPE 2 monitor indicator.
{a)
(k)
(j)
(i)
mewony
{d)} FM MONO | LmaNuUAL
STATION
+ Plcp
itch
(e) (f) (g) (h)
Remote sensor window
37