Controls - GE ADHL22 Owner's Manual

Controls

Appearance may vary by model.
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
Press to turn the dehumidifier on and off.
NOTE: Turning off the power by pressing the Power button
does NOT disconnect the appliance from power supply.
2. Fan Speed Pad
Controls the fan speed.
Press to select either High, Medium, Low, or Smart Dry
fan speed.
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
preferred, set the fan control to Medium or Low. Smart Dry
compares the set humidity level with the actual humidity and
adjusts the fan speed automatically.
3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
4. Humidity Set Control Pads
The humidity level can be set within a range of 35%
RH (Relative Humidity) to 80% RH (Relative Humidity) in 5%
increments or in Nonstop mode for continuous operation. To
set the unit for continuous operation, press the "–" pad until
the "Nonstop" indicator light is illuminated.
NOTE: If Nonstop is selected, the dehumidifier will operate
continuously at its maximum dehumidification settings if
attached to a hose to drain or until the bucket is full. For
drier air, press the "–" pad and set to a lower percent value
(%). For damper air, press the "+" pad and set to a higher
percent value (%). When you first use the dehumidifier,
set the humidity control to 45% or 50%. Allow at least 24
hours for the dehumidifier to achieve the humidity level.
If you still have damper air than desired, set the humidity
level to a lower setting or select Nonstop for maximum
dehumidification.
5. Filter Timer
After 250 hours of operation, the Clean the Filter indicator
light will glow to remind you to clean the filter. Remove the
filter and clean it.
Press and hold Filter button for 3 seconds to reset the filter
reminder. See the Care and Cleaning section.
4
6. Delay Off
While the dehumidifier is operating press the Delay button.
Press the "+" / "–" buttons to select the number of hours
you want the dehumidifier to continue to operate before
turning Off.
NOTE: After displaying the time, the Display will revert to
showing the current humidity after 5 seconds have passed.
Pressing the Delay button will display the number of hours
left on the delay.
Delay On
While the dehumidifier is off press the Delay button.
Press the "+" / "–" buttons to select the number of hours
you want the dehumidifier to remain off before turning On.
NOTE: The display will show the number of hours left until
the dehumidifier turns on.
To cancel the Delay:
Press the Delay button once, the hours remaining on the
Delay will appear on the display. Press the Delay button
again and the Delay will be cancelled.
7. Pump (on some models)
Activates the internal pump function. Press for 3 seconds
to activate the internal pump for automatic removal of
condensate. The internal pump indicator light will remain
illuminated after 3 seconds. Press to deactivate the pump.
Before turning on the pump, ensure the hose is connected.
8. Empty Indicator
The "Empty" indicator will blink when the bucket is ready
to be emptied, or when the bucket is removed and/or not
replaced in the proper position.
9. WiFi Connect Pad (on some models)
Enables connection of the dehumidifier to the home WiFi.
Download SmartHQ App for details at:
GEAppliances.com/connect.
49-5000545 Rev. 3