Craftsman 917.773423 Owner's Manual page 5

Read I hase
l es_a_-tJons a nd_ manual in its
entiretybeforeyou attemptto assernbleor
operateyournew lrimmer.
IMPORTANT: Thistrimmerisshipped
WITHOUT OILOR GASOLINE inthe engine.
yournew ldmmerhas been assombledat tha
facto_ withthe exceptionofthase partsleft
unassembledfor shippingpurposes. Allparts
suchas nuts,washers,belts,etc., necessary
to completethe assemblyhavebeen placed
In the partshag. To ensuresafe and proper
obera_on nf yourtrimmer,all partsand
hardwareyou assemblemust be tightened
securely.Uso _e oonect toolsas necass_y
to ens,xe properUghfz_as.
Loose parts Packed Separately
20 OZ.
Bottle of oU
Tdmmer tJnes
(2)sets
(0.155 dlarnetsr
x 18,75 Inches long)
TO REMOVETRIMMER FROM CARTON
1. Remove loose parts included with
tdmmer.
2. Cut down two end comers of carton
and lay end panel down flat.
3. Remove all packing materials.
4. Roll trimmer out of carton and check
carton thoroughly for additional loose
parts.
HOWTO SET UPYOURTRIMMER
TO UNFOLD HANDLE
IMPORTANT: Unfoldhandle carefulysoas
not to ptechor damagecoo'_ol c ables.
1. Loosen handle knob enough to allow
upper handle to be unfolded from the
shipping position.
2. Raise upper handle section into place
on lower handle and tighten handle
knob.
3. Remove handle padding holding
trimmer head control bar to upper
handle.
Your trimmer handle can be adjusted for
your trimmingcomfort. Refer to "ADJUST
HANDLE" in the Service and Adjustments
section of this manual.
Upper handle
Liftup
knob
handle