Section 4: Troubleshooting; Troubleshooting Guide - Generac Power Systems Power Zone 410 Owner's Manual

Section 4: Troubleshooting

Troubleshooting Guide

Problem Solution
Red LED in front of
Verify 12 V
enclosure is OFF
the Power Zone Pro Main Controller BS6 connector.
Green LED in front Verify the RS-485 wires are connected properly on PWR_RS485 connector to the Power
of enclosure is OFF Zone 410 Controller.
Green LED in front Operating system or application is not working properly. Unplug and plug back the
of enclosure is not PWR_RS485 cable to the Gateway.
blinking
Owner's Manual for Power Zone Gateway on PZ 410
power and ground wires are connected properly on PWR_RS485 connector to
Troubleshooting
31