Generac Power Systems Power Zone 410 Owner's Manual page 27

Configure SNMPv3
1. Enable SNMP (D).
2. Set SNMP version to SNMPv3 (E).
3. Tap "Add User" button (F).
4. For each user, enter user name (H), select user
access level from the dropdown list (J), select
B
C
Letter
A
B
C
D
E
F
G
H
J
K
L
M
Owner's Manual for Power Zone Gateway on PZ 410
Figure 3-40. SNMPv3
Setting Name
Setup
Communications Dropdown.
Select SNMP.
Enable SNMP.
Select SNMP version SNMPv3.
Add user.
Delete entry.
User name. Requests will be rejected if message does not include
matching user name.
Access Level (None, Read Only, Read Write).
Authentication Level setting (No authentication, MD5, SHA).
Encryption setting (No Encryption, 128-bit AES, 256-bit AES-Blumen-
thal, 256-bit AES-Reeder).
Save settings.
authentication level (K) from the dropdown list, and
select the encryption setting from the dropdown
list.
5. To delete a user, use the trash button (G) on the
right side of the screen to delete a user.
6. Tap "Apply Changes" button to save all settings.
L
A
Installation and Operation
D
E
F
G
H
J
K
L
013860
23