Connections - Technics RS-TR979 Operating Instructions Manual

Connections
Make connections in the numbered sequence by using the includ¬
ed cables.
The illustration at the right shows an example of connections
made when this unit is combined with a Technics hi-fi component
system, and shows only the connections to be made to and from
this unit in that combination. Refer to the illustration together with
the instructions provided below.
Note:
Avoid letting the cables touch each other as much as possible,
otherwise noise will be generated.
|T| Connect the stereo connection cables.
[2] Connect the L-type cables.
| ~
3
] Set the power voltage.
(For areas except United Kingdom, Europe, Australia
and N.Z.)
Set the voltage selector to the voltage setting for the area in
which the unit will be used.
[Use a minus (-) screwdriver]--,
This unit
Note:
Note that this unit will be seriously damaged if this set
ting is not made correctly.
FOR UNITED KINGDOM ONLY
BE SURE TO READ THE CAUTION FOR AC
POWER SUPPLY CORD ON PAGE 3 BEFORE
PROCEEDING TO THE STEP 4j .
E Connect the AC power supply cord after you
have connected all other cables and cords.
The configuration of the AC outlet and AC power supply cord
differs according to area.
Amplifier or receiver (not included)
(L)(R)(R)(L)
Compact disc
player
(not included)
SYNCHRO
EDIT REMOTE
-L-type cable
(not included)
Household
AC outlet
(Not supplied for United Kingdom, Europe,
Australia and N.Z.)
If the
power plug
will
not fit your socket, use the
Dower Dlua adaDtor (included!
(For areas except Australia and
Insertion of Connector
Even when the connector is
perfectly inserted, depending on
the type of inlet used, the front
part of the connector may jut out
as shown in the drawing.
However there is no problem us¬
ing the unit.
Placements hints
If this unit is placed near a receiver or a tuner, a ''hum" noise
may be heard during tape playback, recording, or AM recep¬
tion of the receiver or the tuner.
If this occurs, leave as much space as possible between the
units, or place them where there is the least amount of
"hum".
"REMOTE CONTROL IN" terminal
Make a connection from this terminal to the control terminal for a
cassette deck with a Technics amplifier or a Technics receiver.
(For detailed information, refer to the operating instructions of
the Technics amplifier or the Technics receiver.)
"REMOTE CONTROL OUT" terminal
Make a connection from this terminal to the "REMOTE INPUT"
terminal of a Technics graphic equalizer or to the "REMOTE" ter¬
minal of a Technics compact disc player.
(For detailed information, refer to the operating instructions of
the Technics graphic equalizer or the Technics compact disc
player.)
"SYNCHRO EDIT" terminal
Make a connection from this terminal to a terminal that has the
synchro-edit function of a Technics compact disc player.
See page 17. (Contact your dealer for details.)