Tape-Totape Recording.16 - Technics RS-TR979 Operating Instructions Manual

Tape-to-tape Recording
(from DECK 1 to DECK 2)
Either normal, OO2 or metal type cassettes can be used.
1 Insert the cassette for recording into deck 2.
Then insert the cassette for playback into
deck 1.
2
Select the appropriate reverse mode.
Select this mode to record on one side only.
ctz> Select this mode to record on both sides.
/OOThe recording will be made on side "B" after recording
on side "A". The tape will stop at the end of side "B".
In the "cZd" mode:
In case the length of a tape set In the deck 2 is longer
than a tape in the deck 1, the deck 1 repeats the
playback until the deck 2 complete the recording on
both sides, (up to eight times)
3
Select the speed at which the recording will
be made.
[The tape-to-tape recording-speed indicator ("xr or
" [EH ") will illuminate.]
x 1 : For operation at the normal tape speed
[*! : For operation at the high tape speed
■ To temporarily stop tape-to-tape recording
(deck 2 only)
Press the pause button of deck 2.
The playback indicator of deck 2 will begin flashing, and playback
will continue on deck 1.
To resume recording, press the pause button again or press the
playback button of deck 2 corresponding to the side of the tape
being recorded upon.
■ To stop a tape-to-tape recording
Press the stop button of deck 2.
To omit unwanted material during
tape-to-tape recording_
1) Press the pause button of deck 2.
2) Press the pause button again or press the playback button of
deck 2 corresponding to the side of the tape being recorded,
when the tape in deck 1 reaches the point where you want to
resume recording.
4
Press the ATC button of deck 2.
("[m]" indicator flashes.)
ATC will not begin until the next step is executed.
[Recording is also possible without performing ATC.]
5
Press the synchro-start button.
ATC (refer to page 13) will begin, and when it is completed,
recording will begin.
• In order to avoid mis-operations later, be sure to switch
OFF the tape-to-tape recording-speed button (the tape-to-
tape recording-speed indicator will go off) after the tape-
to-tape recording has finished.
To locate a certain tune while In the
tape-to-tape recording mode_
1) Press the stop button of deck 1.
A silent interval of about 4 seconds will then be made on the
tape in deck 2, and then deck 2 will change to the recording
stand-by mode.
2) Press the playback button and then press the rewind/fast-for¬
ward search button of tape deck 1 to locate the desired pro¬
gram.
Repeat this step until the desired program is located.
3) To resume recording, press the synchro-start button.