Turning On The Power And Making Sound - Yamaha HS Series Owner's Manual

Turning on the power and making sound

Once you've set up the speakers, make the settings by following the steps below.
1.
Before connecting this product, make sure that all the devices connected to this product are
turned off.
2.
Turn the output level of the connected devices (such as audio interfaces) down to minimum.
3.
Connect speakers L and R with the included speaker cable.
CAUTION
• You can also use a commercially available speaker cable, but make sure that the cable is designed only for use
with speakers. Using other kinds of cables may cause a fire.
4.
Connect any external devices, and plug in the power cord of this product.
5.
Set the ROOM CONTROL and HIGH TRIM switches on this product to 0 db.
6.
Turn on the power of your connected devices, and then turn this product on (first the rear switch
and then the front knob).
The power/volume knob on the front panel turns the speakers on when you slightly turn the knob clockwise, and
the indicator lights up.
WARNING
• When turning the power off, turn off the power of this product (first the front knob and then the rear switch), and
then turn off any connected devices.
18
HS4, HS3 Owner's Manual
Standby
On
Standby
On (indicator lights up)