Motorola PMLN6521 Installation Manual page 13

Vehicle
Chassis
Ignition
Switch
Figure 7. PMLN6434 & PMLN6431 Vehicular Charger Kit
Refer to Figure 6 on page 10 and Figure 7 on page 11 before routing
or connecting the power cable and use the following procedure:
1. If the car is not equipped with an internal power supply
connection, route the main power cable's red and black leads
through the bulkhead and into the engine compartment. Use an
existing opening or, if necessary, drill a 2 cm (26/32 inch)
diameter hole through the bulkhead. Insert a grommet into the
hole to prevent damage to the power cable. The red and black
leads should be inserted one by one into the hole.
2. Cut the black lead to the desired length and connect it to the
chassis of the vehicle. Verify that the fuse is at a distance of 20
to 30 cm away from the connection point.
3. On the engine side of the bulkhead, connect the red (A+) lead to
the vehicle's battery as follows:
a. Cut the long red lead to the desired length, strip the edge and
crimp a terminal lug (not included) to the lead. Verify that the
fuse is at a distance of 20 to 30 cm away from the connection
point.
b. Connect the red lead to the positive (+) terminal on the
vehicle's battery. Cable tie the wire every 10 cm (4 inches)
along its length.
4. Verify that the cables in the engine compartment do not obstruct
any of the vehicle controls or touch hot or moveable parts of the
engine.
Vehicle
Battery
Red
Black
Bulkhead
Blue
1-AMP Fuse
Interconnection Diagram
11
5-AMP Fuse
Grommet
Power Cable