Programme Selection - Zanussi DS 20 TCR/A Instructions For The Use And Care

Programme Selection
The chart on page 22 gives details of the
programmes which your machine is
designed to carry out. You will soon
discover which programmes suit your type
of washing up.
If you half load the machine and want to
make up a full load later in the day after
another meal, use the rinse and hold
programme.
Starting the Machine
Turn on the water tap which supplies the
machine. Make sure that the machine is
plugged into the electric socket and that
the switch (if any) is on.
Close the door of the machine firmly after
loading it and adding the detergent.
Turn the programme selector knob
clockwise until the index points exactly to
the required programme letter.
If required, press the Economy wash
button and/or Economy drying button.
Note
It is important to press the buttons in the
order shown on the wash cycle chart.
The On/Off button must always be
pressed last (see wash programmes).
Stopping the Machine
The machine will stop automatically at
the end of the wash cycle, and you will
see a white bar lined up with the red bar.
The pilot light will remain on until the
On/Off button is pressed.
To stop the machine during a wash cycle,
press the On/Off button.
To restart the machine press the On/Off
button again and the wash cycle will
resume where it was interrupted.
At the end of a selected programme, the
water and electricity supplies should be
turned off to ensure complete safety
when the machine is left unattended.
If the appliance is able to be operated on
the Electricity Board's (Economy) system
then you should turn off the water and
electricity supplies as soon as possible
upon completion of the selected
programme.
Warning
Do not open the door while the machine is
working. There is a safety device
incorporated which automatically stops
the machine if it is opened accidentally.
21