Screw (quantity)
M1.6 x 4 mm, Zn coated (4)
Dual M.2 or E1.S SSD enclosure
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the M.2 solid-state drive and E1.S solid-state drive installed in the front access bay (if any). See
"M.2 solid-state drive in the front access bay" on page 64 and "E1.S solid-state drive in the front access
bay" on page 66.
2. Remove the left side cover. See "Left side cover" on page 39.
3. Remove the right side cover. See "Right side cover" on page 58.
4. Remove the storage fan assembly. See "Storage fan assembly" on page 63.
5. Disconnect the cable from the dual M.2 or E1.S SSD enclosure. See "System board" on page 32.
Removal steps
Remove the dual M.2 or E1.S SSD enclosure.
Color
Black
Torque
0.8± 0.1 lb/in
.
Chapter 5
CRU replacement
69