Table of Contents
Advertisement
REAR PANEL
1.
POWER CORD:
Tt is is a standard three-pronged AC power cable for connection
to any standard grounded llOVac outlet.
2.
FUSE:
Replace ONLY with same type Fastblow fuse.
U.S., Canada and Japan models:
250Vac, 1/2A Fastblow
Standard model:
250Vac, .125A Fastblow
MAIN OUTPUTS
3.
UNBALANCED:
This output, a 1/4" monaural phone jack, is to connect the BBE
383 Bass Guitar Pre-amp to the next subsequent component in the system.
Used in conjunction with the Master Volume, this output can accommodate any
required output level.
4.
BALANCED:
This output, a balanced XLR jack, is to connect the BBE 383 Bass
Guitar Pre-amp to a mixing console or tape deck.
Used in conjunction with the
Master Volume, this output can accommodate any required output level.
XLR GROUND LIFT
5. LIFTED:
Use this switch to disable the ground pin of the XLR connector.
This
is a useful feature in eliminating a ground loop between the BBE 383 Bass
Guitar Pre-amp and any subsequent component in the signal chain.
CROSSOVER
The BBE 383 Bass Guitar Pre-amp can accommodate a bi-amped bass system
by utilizing the two outputs in the crossover section.
6.
HIGH:
This jack is the output for the high frequency content as determined by
the Crossover controls on the front panel.
7.
LOW:
This jack is the output for the low frequency content as determined by the
Crossover controls on the front panel.
5
Advertisement
Table of Contents
