Table of Contents
Advertisement
Install remote control batteries
1. Open the remote control battery cover.
2. Insert the supplied batteries, ensuring the positive and negative ends are facing in the
correct direction.
The supplied batteries are provided for your convenience so that you can operate the display straight
away. You should replace them as soon as possible.
3. Put the cover back on.
Use BenQ Board by remote control
1. Insert the remote control USB receiver into the USB-A ports at the lower left corner on the
rear side of the display.
2. Aim the remote control at the sensor at the display's bottom-right side within a distance of
less than 8m, and a horizontal and vertical angle of less than 60 degrees.
• The remote control and the USB receiver have been paired by default.
• This remote control applies only to a specific model and operating systems. Contact your reseller if you
have any question.
Max. 8 m
13
Advertisement
Table of Contents
