Table of Contents
Advertisement
Issue
Tea residue or lipstick marks on
dishware.
There are colored coatings (blue,
yellow, brown) inside the appliance
or on stainless steel dishware that
are difficult or impossible to
remove.
Plastic parts inside the appliance
are discolored.
Plastic parts are discolored.
There are removable streaks on
glasses, glassware with a metallic
appearance and silverware.
Irreversible clouding of glassware.
Cause and troubleshooting
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
The formation of films is due to substances contained in vegetables (cabbage,
celery, potatoes, noodles, etc.) or tap water (manganese).
Clean the appliance.
▶
You can remove coatings with Mechanical cleaning → Page 23 or a machine
cleaning product. It may not always be possible to completely remove coatings
but they are harmless to health.
The formation of films is due to metal components on silver or aluminum dishware.
Clean the appliance.
▶
You can remove coatings with Mechanical cleaning → Page 23 or a machine
cleaning product. It may not always be possible to completely remove coatings
but they are harmless to health.
Plastic parts inside the appliance may become discolored over the life of the
dishwasher.
Discoloration may come about and will not impair functioning of the appliance.
▶
Dishwashing temperature is too low.
Select a program with a higher dishwashing temperature.
▶
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
Amount of rinse aid to be dispensed is set too high.
Set the rinse aid system to a lower setting.
▶
→ "Setting the amount of rinse aid", Page 15
No rinse aid has been added.
Add rinse aid.
▶
→ "Adding rinse aid", Page 15
There is detergent residue in the final rinse. Lid of detergent dispenser is blocked by
dishware and will not open fully.
Arrange dishware in the upper rack so the tab collecting tray is not obstructed by
1.
dishware.
→ "Loading dishware", Page 18
Items of dishware are blocking the dispenser lid.
Do not place dishware or fragrance dispensers in the tab collecting tray.
2.
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
Glasses are not dishwasher-proof, only suitable for dishwashers.
Use dishwasher-proof glasses.
▶
Glasses are usually only suitable for cleaning in a dishwasher, i.e. long-term
wear or long-term changes must be expected.
Avoid a lengthy steam phase (standing time after wash cycle ends).
▶
Use a program with a lower temperature.
▶
Use detergent with a glass protection component.
▶
Troubleshooting en-us
31
Advertisement
Table of Contents
