Table of Contents
Advertisement
OPERATING THE TUNER ©
Presa the POWER switch to the ON position.
Select TUNER with the input selector.
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
Switch ON the SPEAKERS button corresponding to the speakers
you wish to use.
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the MONO indicator
in the display section lights or goes out.
@
if an FM stereo broadcast is received when the MONO
indicator is out, the STEREO indicator lights, and sound is in
stereo.
@
if an FM stereo broadcast is received when the MONO
indicator is lit, the sound will be monaural.
H there is
interference during stereo mode reception, switch to mono.
The sound will become
monaural but interference will be
reduced.
TUNING INTO STATIONS
Turn the multi-jog, and the tuning frequency changes, (Switch
off when the GUI MODE button is on.)
Turning in a clockwise direction raises the frequency, while
turning in a counter-clockwise direction lowers the frequency.
1. Use the FM/AM button to select either FM or AM.
Confirm that the JOG MODE indicator in the display shows
"FREQ",
if "ST" is displayed, press the SELECT button to switch to
"FREQ".
2. Turn the multi-jog until you reach the frequency of a
desired station.
When a stations is received, the TUNED indicator will light
up.
NOTE:
The TUNED indicator may not light with broadcasts received
over long distances,
or when
the broadcast signals are
extremely weak.
3.
Adjust the volume and tone as desired.
Auto tuning
Auto tuning is convenient when you do not remember the
frequency of a desired station, or when you wish to find stations
that you do not normally listen to, Operate by remote control.
(Refer to page 23.)
You can also perform Auto tuning GUI. (See page 25.)
Switch off when the GUI MODE button is on.
1. Tune into the desired station.
See the section "TUNING
INTO STATIONS".
In addition to
Station frequencies, the MPX MODE (auto stereo mode or
monaural mode} can also be preset (FM only}.
2.
Press the MEMORY button.
The station (channel) number flashes in the display. (Memory
mode}
3. Turn the multi-jog to select the station (channel) you
want to memorize, and press the ENTER button.
@ The station {channel} number
lights in the display,
indicating that it has been memorized.
®
if you do not press the ENTER button within about five
seconds after selecting a station, the memory mode is
canceled.
4. Repeat steps 1 to 3 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you
store a new preset, it takes the place of the previously stored
station (if any).
You can also preset using GUI. (See page 25.)
7
<ARB7059>
Advertisement
Table of Contents
