Install The Ion 1000 In Control Mode - PaloAlto Networks TECHDOCS ION 1000 Hardware Reference Manual

Install the ION 1000

Install the ION 1000 in Control Mode

Install the Prisma SD-WAN ION 1000 in control mode.
STEP 1 | Plan and prepare for cabling and connection of the ION 1000 to insert it into your network.
Ensure that internet access using a private WAN connection or direct internet broadband is
available at your site to allow remote configuration of the ION 1000.
STEP 2 |
Power on the ION 1000 and connect the cables:
1. Connect the power cable to the power adapter and the adapter to the ION device.
2. Next, plug the device power cable into an AC power outlet. When the device is powered
on, the power indicator turns green.
STEP 3 |
Connect the internet or WAN or LAN ports:
1. Connect the ION device port 1 or 2 to a DHCP-enabled network that has access to the
internet, such as an Internet Service Provider (ISP) cable modem.
2. If there are no DHCP-enabled networks, access the console and
1 or 2.
STEP 4 | Verify the device connection to the Prisma SD-WAN controller.
Upon successful connection, the controller connectivity indicator light on the ION device turns
to green. The ION device is now connected to the Prisma SD-WAN controller and displays on
the Prisma SD-WAN console under Unclaimed Devices.
STEP 5 |
Connect to the Prisma SD-WAN console.
1. Log in to the Prisma SD-WAN console using the provided login credentials.
2. Navigate to Map > Unclaimed Devices to verify that the ION device is listed as Online
under Unclaimed Devices.
3. Select the device and Claim the device.
STEP 6 | Next Step: Proceed to
ION 1000 Hardware Reference
assign the device and
28
configure it to a site.
assign a static IP on port
2023 Palo Alto Networks, Inc.
©