How To Use The Filter Check Alarm Function By Filter Clogging (800/1000/1500/2000 Cmh) - LG LZ-H020GBA6 Installation Manual

How to use the filter check alarm function by filter clogging
(800/1000/1500/2000 CMH)
• To enable the filter check alarm function, you must set "test run" in the installer settings on the
remote control.
• After the test run is finished, the product will turn off.
• During the test run, the remote control will not turn off the power.
• Noise caused by operation mode change during test run may occur, but this is not a product error.
• Check filter contamination before test run operation.
• Except for rated voltage(220~240 V), it can be detected incorrectly.
• It may be affected by the external environment, but this is not a product error.
!
CAUTION
• If the test run function is not used, the filter check alarm function can not be used.
• After T.A.B and filter and PCB replacement, test run must be performed.
• Some categories of the menu may not be displayed according to the function of the
product, or the menu name may be different.
• For more details, refer to the remote controller manual.
Installation
Installation manual 23