Clamping The Workpiece; Cleaning And Maintenance - Parkside 345868 2004 Translation Of The Original Instructions

♦ Swing the pendulum cover
and hold it firmly in place with your hand.
♦ Press the spindle lock
hold it in this position. If necessary, rotate the
cutting disc by hand until this is possible.
♦ Use the hex key supplied (large)
the fixing nut out in an anticlockwise direc-
tion.
♦ Remove the plane washer
flange (outside)
♦ Insert a new cutting disc.
♦ Proceed in reverse order in order to reassemble
the appliance to a usable condition.
♦ Check whether all the fastening elements are
correctly fitted.
NOTE
► Ensure that the cutting disc
freely.
► Switch the appliance on for around 60 seconds
to check that there are no unusual vibrations.
If this is not the case, you should check that
the cutting disc is installed correctly

Clamping the workpiece

You can clamp the workpiece and adjust the mitre
angle with the aid of the fitted vice.
Using the vice
♦ Turn the handle on the vice
clamp the workpiece.
♦ Turn the handle on the vice
unclamp the workpiece.
NOTE
► You can also fold the rapid adjustment
upwards in order to make a quick adjustment
to the vice . Fold the rapid adjustment
down again in order to fix the vice
this, use the vice
adjustments.
PMTS 180 A1
back completely
all the way down and
to unscrew
, the clamping
and the cutting disc
can be rotated
.
clockwise to
anticlockwise to
. After
handle to make fine
Setting the cutting angle (mitre angle)
♦ Undo the cutting angle adjustment
it anticlockwise. If necessary, pull the cutting
angle adjustment
♦ Set the required cutting angle using the angle
given.
♦ Retighten the cutting angle adjustment
turning it clockwise.

Cleaning and maintenance

.
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
■ Clean the ventilation slits in your power tool
with a soft brush regularly.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
► Required maintenance work should only be
replaced by qualified service personnel.
by turning
upwards.
by
GB │ MT │
55 ■