Technics SL-MC60 Operating Instructions Manual page 7

How to set discs
! □
Pulling gently from both ends, open the front
panel.
Caution
• Except when setting or removing discs, keep hands out of
the changer while open. You could injure yourself if some¬
how entangled in the internal mechanism.
• Keep cassette tapes away from the magnetic latches.
Slide the loader carriage to the slot No. where
wanting to insert the disc.
mm
Slot No. 0 (SINGLE) is reserved for single disc play.
(See page 10.)
03
r
s
Set the disc on the loader and flip the loader
upwards.
Caution
• Do not use 3" (8 cm) discs fitted with expander rings.
Expander rings could damage the disc slots.
• Do not use cleaning discs or warped discs. All of these
could damage your changer.
• Do not use discs with poorly attached labels or stickers.
Adhesive protruding from peeled off stickers can cause the
changer to malfunction.
• Do not put anything other than discs in the changer.
Close gently the front panel.
mm
If you leave the front panel open while a disc is in play, when
the disc is over, the changer will stop.
How to remove discs
1. Open the front panel.
2. Slide the loader carriage to the slot you want.
3. Press the eject button on the loader carriage.
Special notes
You can set discs in the slots and remove them too, while playing
discs.
• Do not set a disc in the slot of the disc being played (slot flashes).
The disc in play is returned to its slot when finished. If two discs
somehow jam the slot, one or both could be damaged. When this
happens, the message 'TAKE OUT" will appear on the display.
Remove the disc that doesn't belong in the slot and press the stop
button.
• Do not open the front panel while the changer is changing discs.
• Sometimes the front panel cannot be opened while a disc is play¬
ing. It is a question of time. In such case, wait until you can open
it.