Technics SL-MC60 Operating Instructions Manual page 15

Program play
To check programmed contents Q
(only available from the remote control)
Press RECALL.
Each time you press RECALL, the display shows the programmed
disc and track number in the sequence you have entered.
To clear a single item from the program B
(only available from the remote control)
[In the stop mode]
Press CLEAR.
Each time you press CLEAR, you will cancel the last entry in the
order you have entered all selections.
To clear an entry in the middle of the program sequence, press
RECALL repeatedly until the display shows the selection to be
cleared, and then press CLEAR within three seconds after that.
To quit the program mode E
[In the stop mode]
Press PROGRAM.
The changer will return to the sequential play mode.
The programmed contents will remain stored in memory until they
are cleared, even after the program mode is canceled.
Therefore, after program, it is possible to cancel the program mode
and use another play mode and then hear the same program again
at a later time.
In addition, if discs are changed, the program will be played using
the new discs. If non-existing entries are found at this time, the
changer will cancel them
For your reference
The program will remain stored in memory even after the unit is
switched off.
However, if the power cord is unplugged or the power supply is
otherwise interrupted for an extended length of time, the contents
will be erased from memory.
Special note on recording programs
The changer needs time to change the discs and find the tracks.
Consequently, it will take the changer slightly longer than the total
track time to record everything. Exactly how much longer it will be
will depend on the contents of the program.