Installation And Connection; Installation Equipment; Planning The Installation - Kenwood TK-705D Instruction Manual
Vhf/uhf fm transceiver
Hide thumbs
Also See for TK-705D:
- Service manual (41 pages) ,
- Service manual (64 pages) ,
- Instruction manual (16 pages)
Table of Contents
Advertisement
4.
INSTALLATION AND CONNECTION
| WARNING
| interference with vehicular electronics
- Electronic fuel injection systems,
'electronic antiskid braking systems, electronic cruise control systems, etc.,
'аге
typica!
of the types
of electronic
devices
which
may
be prone
to |
: malfunction due to the lack of protection from radio frequency energy which is |
| present when transmitting. If the vehicle contains such equipment, consult the
dealer for the make of vehicle and enlist his aid in determining
if such |
: electronic circuits will perform normally when the radio is transmitting.
: NOTE
The following instructions are for use by your KENWOOD
dealer; either an
- authorized KENWOOD service facility, or the factory only.
4-1.
INSTALLATION
EQUIPMENT
CAUTION
|
Ве careful to avoid damaging some vital part of the vehicle when drilling :
| mounting holes. Always check to see how far the mounting screws will extend Å
' below the mounting surface before installing.
|
The following tools are required for installing this two-way radio.
@ 1/4" or larger electric drill.
© Drills and circie cutters. (Sizes listed below.)
DRILL SIZES
¢42mm_
for 25х16 self-tapping screws.(Large)
932тт
for $4X16 self-tapping screws.(Small)
4-2.
PLANNING THE INSTALLATION
The accompanying
illustrations should help you in planning your installation.
Before starting, plan your installation carefully so that it will be convenient for
the operator to use, protected from water damage, easy to service, and out of
the way of auto mechanics and passengers.
Advertisement
Table of Contents
