Table of Contents
Advertisement
eenneeos
eneanano7
a@eeen
8 805
eeeane
103
|
a
a@#ol
104
106
108
MHz
400
600
kHz
on
1
10 100 400 tk 4k 12k
© ACOUSTIC indicator
Shows the number of the acoustic setting memory, [1],
(2 Jor[3]}.
© Video 2 input indicator
Indicates the selected front or rear video 2 inputs.
@ Video monitor indicator
The indication [1}appears when the VIDEO 1
FUNCTION key is pressed; (2]appears when the
VIDEO 2 key is pressed; [TV appears when the TV key
is pressed.
© PROTECTOR indicator
Appears when the protection circuit against a short-
circuit is activated.
© ERASE indicator
Appears when the MEMORY ERASE key is pressed.
@ FM IF band indicator
The selected FM IF band is graphically displayed: 7—~\
(wide) or /\ (normal).
© ATT (attenuatonSIGNAL (signal strength) indicator
Normally the volume attenuation level is indicated in
dB. When the METER SELECT key is pressed in
TUNER mode, the signal strength is indicated in dB.
@ FM level indicator
The FM station level selected by the FM LEVEL select
key is displayed.
@ Station spectrum display
The frequencies of the receivable stations located by
station searching are shown by the squares. When a
station is tuned in, the corresponding square flashes.
@ Memory indicator
Appears when the MEMORY PRESET key is pressed.
@ Function indicator
Indicates the selected program other than broadcasts.
@ FM ANTENNA indicator
The CATV [A] appears when the FM ANT-A (CATV)
key is pressed; [8] appears when the FM ANT-B key is
pressed.
@ BALANCE indicator
Indicates the relative strength of the volume at the left
and right speakers.
@ TONE indicator
Graphically shows the tone control characteristics. A
straight bar graph indicates a flat frequency response.
© Power output spectrum display
The power output (in wattage) is displayed in five
frequency bands.
When the METER SELECT key is pressed, the "x 1/10"
indication appears to indicate that the scale numbers
are read by 1/10 (i.e. for 0.1, read 0.01.)
© SIGNAL strength meter
When the METER SELECT key is pressed in TUNER
mode, the received signal strength is indicated in five
steps.
Advertisement
Table of Contents
