Table of Contents
Advertisement
VIDEO TAPE EDITING
To edit a video tape, connect a VCR for playback to the
VIDEO 2 VIDEO IN/AUDIO IN jacks and a VCR for recording
to the VIDEO 1 VIDEO OUT/AUDIO OUT jacks.
wae
Video signals
=>
Audio signals
(for playback)
(for recording)
1 Turn on the receiver and equipment to be used.
2 Press the VIDEO 2 key.
3 Select the front or rear video 2 inputs with the F/R key.
4 Press the EDIT VIDEO key.
5 Set the VCR 2 to playback mode.
6 Set the VCR 1 to recording mode. Editing will begin.
You can listen to an audio program source during video tape
editing by pressing any FUNCTION key.
Note
You cannot edit a video tape from VCR 1 to VCR 2.
ADDING NEW SOUND ON A VIDEO
TAPE DURING EDITING
During video tape editing, you can replace the sound
previously recorded on a video tape with the desired sound
from an audio source, thus making your own personalized
video tape.
Turntable system
1 Turn on the receiver and connected equipment.
Component TV
2 Press the VIDEO 2 key.
3 Select the front or rear video 2 inputs with the F/R key.
4 Insert a recorded video tape into the VCR 2 and set it to
playback mode.
5 at the point where audio dubbing is to start, press the
PAUSE button on the VCR 2.
6 Press the EDIT AUDIO key on the receiver.
7 Press the desired FUNCTION key.
8 Release the pause mode of the VCR 2 and set the VCR 1
to recording mode.
9 start playing the selected program source.
aie
Advertisement
Table of Contents
