To set a receiver channel output to mute:
1.
AUDIO > MUTE
2.
Use the control wheel to select ON or OFF.
3.
Press ENTER to save.
To unmute the receiver output:
Simultaneously press the ▲▼ buttons or select OFF from the MUTE menu option.
Tip: Audio mute can be enabled remotely from Wireless Workbench or from an external controller.
Important! A power cycle will reset the receiver and unmute the audio output.
Transmitter Input Clip
The following warning displays on the receiver LCD panel when the transmitter input is clipped:
To correct, select INPUT PAD from the main menu and attenuate the input signal by 12 dB. If the warning persists, reduce the
level of input signal.
Audio Signal Encryption
When encryption is enabled, the receiver generates a unique encryption key which is shared with a the transmitter during an IR
sync. Transmitters and receivers that share an encryption key form a protected audio path, preventing unauthorized access
from other receivers.
Note: For some units, encryption is always on and cannot be configured.
Encrypting a Single Transmitter to a Single Receiver
From the receiver menu: DEVICE UTILITIES > ENCRYPTION > ON (Auto)
1.
2.
Press ENTER.
3.
Perform an IR Sync to share the encryption key with the selected transmitter.
Encrypting Multiple Transmitters to a Single Receiver
Multiple transmitters can share the same encryption key, allowing them access to a single receiver. Use this method if you
have multiple instruments or wish to use a combination of handheld and bodypack transmitters.
1.
From the receiver menu: DEVICE UTILITIES > ENCRYPTION > ON (Manual) > KEEP KEYS.
2.
Press ENTER.
3.
Perform an IR Sync to share the encryption key with the first transmitter.
4.
Turn off the transmitter and perform an IR Sync to share the key additional transmitters.
Caution! Make sure only one transmitter is turned on during an IR sync or a performance to avoid causing cross interference between transmitters.
Shure Incorporated
21/49