Panasonic Omnivision PV-M1349 Operating Instructions Manual page 5

'O1U) Caloleyaw Wap t-ialaremerelatatzveq ile) ats
Unhook the antenna from your
previous TV or VCR and UHF/VHF Band
connect it to the back of the Mixer (not a
Combination VCR as shown in (Fiat)Twin Lead
the diagram.
300 Ohm Cable ——-=t
If your antenna system has (Round) 75 nae
separate UHF and VHF lead- coaxial Cabs
ins, you need a UHF/VHF
Band Mixer (not supplied.) Back of —
; fom —e-------- Combination
Antenna
VCR
(Flat)Twin Lead 300-75 ohm
300 Ohm Cabt Transformer
° =r (not supplied)
BLSY~Y/ OF] e](=m ele) a Ore) alal-veaile) at
®@ Without a Cable Box
Combination VCR
* record or view scrambled channels.
* view a channel other than the one
selected for any type of recording.
@ With a Cable Box
You can;
* record or view any channel including scrambled channels.
NOTE: Channe! selection must be made at the cable box.
You cannot;
* view a channel other than the one selected for any
type of recording.
¢ do a Timer recording of a channel unless you select it
at the cable box.
Antenna
or
Cable Box
Note to CABLE System Installer
This reminder is provided to call the CABLE (Cable TV) System
Installers attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system
of the building, as close to the point of cable entry as practical.
@ With a DSS Receiver
You can;
* record or view any channel including scrambled
channels.
NOTE: Channel! selection must be made at the DSS Receiver.
You cannot;
* view a channel other than the one selected for any
type of recording.
* do a Timer recording of a channel unless you select it
at the DSS box.
NOTE: The DSS receiver must be turned off to view programs from
a cable box or antenna. See the DSS manual for details.
Antenna
or
CABLE
Satellite
Wreybl wel I-1-75