Advertisement
Installation
Model 11869A
Figure 2-5.
Installation (6 of 6)
11,
Installing the Latch Handle
An improved latch handle for the RF Plug-In is supplied with the
11869A,
together with a spring, washer, and flat screw for
installation. The new latch is longer to conform with the shape of
the 8350A, and when installed will protrude below the base of the
Plug-In.
Remove the old latch handle from the left side of the Plug-In.
Install the new latch in the same location, tensing the spring to
fit behind the front panel of the Plug-In. Place the washer between
the latch handle and the Plug-In, and tighten the screw to hold the
latch handle in place.
12.
Installing the Plug-In and Adapter in the Mainframe
Pull the latch handle on the left side of the Plug-In forward and
upward. Install the Plug-In/Adapter assembly into the Plug-In
compartment of the 8350A Mainframe. Push down on the latch to lock
the Plug-In assembly into the 8350A.
Interconnections between the
Plug-In and the Mainframe are now complete.
2-10
Advertisement
