Advertisement
Remove 2 screws on front panel, removing the cover on upper end and area/section plate. Lift off front
case holding sides at top. Disconnect the intercom by unplugging the connector.
Open a cable inlet hole (rubber part) on bottom of chassis. Pull in cable(s), and make wire terminations.
Use attached cable clamps(s) for neat and secured connection. Reconnect and mount front case to
chassis, attaching the cover and plate in place.
When wall-mounting, separate the front panel from chassis, as explained above. Install the chassis
upside down on the wall, onto a single-gang or two-gang box.
★ TC-M master wall-mounts with TC-G (and TB-AD10) attached.
Decide the exact location of TB-M master, and use the following measurements to mount the add-on components.
-9-
Advertisement
