Rinnai INFINITY R1385G Installation Manual

INFINITY pipe cover
Installation guide
Before installation check for damage, do not install any damaged items, and check all components
have been supplied. Read these instructions to get an overview of the steps required before
starting.
With Rinnai's current range of water heaters, assembly can be done by the homeowner—this is
because assembly does not require taking the cover off the water heater.
The pipe cover is approximately the same width and depth of the water heater and conceals
approximately 450 mm of pipework below the unit.
Pipe cover Suitable for
R1385 Rinnai INF A16-A26
Rinnai INF VT16-VT26*
R1385G
Rinnai INF A26 Graphite™
R1402SC Rinnai INF HD250*
R1408 Rinnai INF EF24*
R1408SC
Rinnai INF HD200 / HDi200*
R1416 Rinnai INF EF26
* Discontinued models
If the screw pack is lost a replacement pack can be ordered:
R5060 / R5060G* - Screw pack INFINITY pipe cover.
* R5060G is the graphite pack for the graphite pipe cover
Important
Before installing the pipe cover turn off the power, water, and gas to the water heater.
IMPORTANT
Assembly
1. Assemble the top frame to the right and
left side panels with four M4 screws and
washers. Note the orientation of the frame,
fold faces up, this is the only way it will fit
on the water heater.
2. Secure the bottom bracket to the left
and right panels with two M4 screws and
washers.
3. Secure the rear bracket to the left and right
panels with two M4 screws and washers.
Rinnai New Zealand Ltd (0800 746 624)
Top frame
Bottom bracket
Rear bracket
Screw M4 INF Screw M4 x 8
pipe cover (x2)
SS (x8)
Side panel LH
1 of 2
Side panel LH Front panel
Side panel RH
Nylon washer
M4 (x10)
PK screw #8 x 6
SS (x2)
PK screw #10 x 40
ZP (x2)
Side panel RH
Top panel Top panel
Note orientation, fold is
facing up—only way it
will fit on the INF.
Rear
bracket
Bottom bracket
INF pipe cover installation 9509-H I 08-23