Orion HCCA3000.1DSPLX Manual page 15

PHASE SHIFT CONTROL
• 0 Degree - Leaves output unaffected. The output signal is in phase with
the input signal.
• 180 Degree - Inverts the output. The channel is 180 degrees output of
phase. This conf iguration is useful for inverting the phase of subwoofers
to improve staging in a vehicle.
BRIDGED MODE
Controls whether the amplif ier is a Slave or Master when connected in
combined amplif ier conf igurations.
(Refer to the Amplif ier Wiring section of this manual)
FUSE
Do not use a fuse with a higher value and never bridge the fuse over, as this
may lead to irreparable damage so that any claim for warranty is denied.
GND(-)=GROUND CONNECTION
Connect the GND terminal to the chassis ground of your car and take care
of electrical and mechanical contacts. In doing so, drill a hole into the car
chassis near the amplif ier then remove paint, dirt or any other substance
f rom the ground point. There after fasten the cable end with adding a
ring terminal by using a screw or bolt. Ensure that the ground connection
is as short as possible (no longer then 24") and that the cable diameter
is suff icient (min 10awg.). Route the ground cables f rom the radio and all
other equipment parts, like equalizer, active crossover network or other
amplif iers, to the same ground point.
+12V = POWER SUPPLY
Connect the BATT terminal to the positive pole of the battery with a lead
cable and add a fuse into the power cable in a distance of no more than 18"
f rom the battery. The lead cable's diameter should be at least 10awg for a
length of 6ft. and 8awg. for a length of more then 6ft..
REM(ON/OFF) REMOTE CONTROL
Connect the REM terminal to the radio's connector that gives +12V when
on. Now when turning on and off your car radio. the amplif ier automatically
switches ON and OFF. If using the radio antenna signal, make sure that the
signal does not turn off when in another mode.
SPEAKERS
Connect the speakers to these terminals.
ATTENTION! Some remote turn on signals may be to weak to turn on the
amplif ier, if this is the case you will need to use a relay to increase the
remote turn on signal.
OPERATIONS
14