Kenwood TS-430S Instruction Manual page 17

5.8 MOBILE OPERATION
Being compact in design, this transceiver is ideal for mo-
bile operation. Satisfactory mobile operation is achieved
through proper power and antenna connection, and
thoughtful transceiver installation and adjustment.
5.8.1. TS-430S INSTALLATION
Secure the TS-430S under the dashboard using an option-
al MB-430 mounting bracket as shown in fig. 5-8. As an
alternative, use strapping, making sure that the TS-430S
will not slip out of place while operating the vehicle.
NOTES:
1. Do not install the TS-430S near the heater outlet.
2. Allow sufficient space behind the TS-430S to ensure
proper ventilation.
5.8.2. CONNECTING THE POWER CABLE
When connecting or disconnecting the power cable to or
from the power connector, be sure that the power switch
is always in the "OFF" position. Observe polarity of the ca-
ble. The TS-430S operates on 13.8V DC, negative
ground. Battery polarity must be correct. The power cord
is color coded.:
Loading coil _
Antenna bracket must have
nn
Antenna good metal to metal contact
Antenna bracket
must have good
metal to metal
contact
To antenna terminal
Bumper mounting
bracket
Pass coaxial cable
through the drain hole.
12V
Battery
Since an HF antenna is large and heavy, it must be installed to withstand
high wind stress.
Use short heavy leads
Fuse should be as close to the battery
terminal as possible.
Fig. 5-8 Mobile Operation
Use fuse block, battery acc-
essory position, 20A minim-
um rating
TS-430S
Fuse
Turn POWER switch OFF
before connecting/
disconnecting the power cord
17