Replacing The Power Inlet And The Residual Current Device (Rcd) - Husqvarna PP492HF Workshop Manual

11
1
3
5
7
1 2 8
REPAIR INSTRUCTIONS
2
4
6
8
Replacing the Power Inlet
and the Residual current
device (RCD)
First see: Opening the PP 490,
PP 492 (p. 124)
1� Remove the 4 screws that holds
the power plug� Mark and unscrew
the wires�
2� Remove the plastic cover to the
Residual current device (RCD)�
3� Unscrew the water inlet�
4� Remove the 4 screws that holds
the end cover side in position�
(picture shows only the screws on
the left side)
5� Mark the cable positions and
unscrew the upper cables on the
Residual current device (RCD)�
6� Move the power inlet cables to
the new Residual current device
(RCD)�
7� Screw the upper cables back to the
new personal safety guard�
8� Check and grease the O-ring on
the water inlet�