GE GFWH1200 Owner's Manual & Installation Instructions page 8

Control settings.
14
Ext Tumble
15
16
17
or
(depending on model)
18
or
(depending on model)
19
(appearance will vary
and not all features
on all models)
8
Extended Tumble
(on some models)
Freshly tumbles your garments periodically
for up to 8 hours after the wash cycle is
complete to lessen the setting of wrinkles
and creases when you are not able to
move clothing to the dryer right away.
Volume
This button has two functions:
To change the loudness of the end of
cycle signal, press the button as many
times as needed to reach the desired
volume. There are four sound levels
including OFF.
Cycle Signal
Use the Signal pad to change
the volume of the end of cycle signal.
Lock Controls or Lock
(depending on model)
You can lock the controls to prevent any
selections from being made. Or you can
lock or unlock the controls after you have
started a cycle.
Children cannot accidentally start the
washer by touching buttons with this
option selected.
To lock the washer, press and hold the
Lock Controls or Lock button for 3
seconds.
Start/Pause-Add A Garment
Press to start a wash cycle. If the washer
is running, pressing it once will pause the
washer and unlock the door. It will take a few
seconds for the door to unlock after pressing
Pause. Press again to restart the wash cycle.
NOTE: If the washer is paused and the cycle
is not restarted within 15 minutes, the current
wash cycle will be cancelled.
Display
Displays the approximate time remaining
until the end of the cycle.
NOTE: The cycle time is affected by the
water pressure in your home and the
balance of the load in the washer. You
may see the time remaining on the
display increase to accommodate a
At the end of the cycle, the display will
scroll "END" and after ten minutes the
Extended Tumble will begin. It can be
stopped at any time by pressing the Power
button.
Note: The Extended Tumble option cannot
be added to the My Cycle feature.
To turn the button sounds ON/OFF, press
and hold the button for 3 seconds.
Press the pad until you reach
the desired volume.
To unlock the washer controls, press and
hold the Lock Controls or Lock button for
3 seconds.
A sound is made to indicate the lock/
unlock status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE: The Power button can still be used
when the machine is locked.
NOTE: In some cycles the washer will drain
first, then unlock the door when it is paused.
NOTE: The washer performs automatic
system checks after pressing the Start
button. Water will flow in 45 seconds or
less. You may hear the door lock and unlock
before water flows; this is normal.
slower spin speed to handle unbalanced
loads.
On some models, cycle status is also
displayed and certain features such as
Delay Wash or Steam are shown indicating
they have been selected.