Product Overview; Installing The Traction Control Linkage - Toro Power Max 826LE Operator's Manual

Product Overview

3
4
2
1
5
9
10
1. Auger/impeller lever
2. Speed selector lever
3. Quick Stick discharge
chute control
4. Traction lever
5. Fuel tank
6. Engine oil fill tube/ dipstick
4
1
2
3
1. Ignition switch
2. Choke
3. Throttle
6
7
8
12
m-6936
11
7. Chute deflector
8. Discharge chute
9. Fuel shutoff valve
10. Skid (2)
11. Auger
12. Scraper
5
6
4. Primer
5. Electric starter
6. Recoil starter
3329-792 Rev A
6
Setup
Installing the Upper Handle
Assembly
1. Lift and rotate the upper handle assembly and
position it over the lower handle.
Note: Ensure that the 2 cables attached to the
Quick Stick are routed inside the upper handle
legs and that the 2 lever cables and the wire for
the headlight are not pinched between the handle
sections.
2. Secure the upper handle assembly with 4 handle
bolts, 4 curved spacers, and 4 locknuts from the
loose parts bag.
Installing the Traction
Control Linkage
1. Remove the hairpin cotter and washer from the
the lower end of the speed control rod (A) and insert
the lower end of the rod into the lower link arm (B) so
that the bent end of the speed control rod faces
rearward.
2. Secure the lower end of the speed control rod
with the washer and hairpin cotter that you previously
removed.
m-6964
A
B
m-6899