Table of Contents
Advertisement
10.
Install the seat base.
Note:
You may need to position the 2 center
seat-belt anchors to allow the seat to drop into
place. Loosen the 2 locknuts (7/16 inch) on the
2 center seat-belt anchors, and tighten the 2
locknuts (7/16 inch) to 72 to 88 N∙m (53 to 65
ft-lb) after adjusting the position.
11.
Remove the backing from the right, front and
left, front foam seals and attach the seals to the
machine
(Figure
Figure 15
1. Left, front foam seal
12.
Remove the backing from the foam seal and
attach the seal to the right side of the machine
(Figure
16).
Figure 16
Right Side Shown
1. Foam seal
15).
7
Routing the Wire Harness
Parts needed for this procedure:
1
Fuse block
Hex-washer head screw (#10 x 3/4 inch)—for electric
2
machines with Serial No. 403448001 and after only
Serrated nut (#10)—for electric machines with Serial
2
No. 403448001 and after only
Self-tapping screw—for gasoline machines with
2
Serial No. 403448001 and after only
1
Fuse (15 A)
For Electric Machines
Important:
The Power Converter Kit is required
to use the cab on a Workman GTX Electric utility
vehicle. Contact your authorized Toro distributor
for more information.
1.
Install the new fuse block as follows:
g035254
•
For machines with Serial No. 403448001
and before, snap the new fuse block onto
the existing fuse block on the machine
(Figure
g037104
1. To ground
2. To the fused wire
11
17).
Figure 17
3. To the optional washer
pump kit
4. New fuse block
g035257
Advertisement
Table of Contents
