U-Line UONP115SS01B Quick Start Manual page 21

QUICK START GUIDE
1. Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
2. Insert arrow clips into holes
Remove bottom hinge:
1. Remove bottom hinge from cabinet using a 1/4"
socket.
2. Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
nuts if used.
PREPARE DOOR FOR REINSTALLATION
Rotate gasket
1. With a flat tool, such as a
putty knife, gently pry up
beneath the gasket and
spacer until completely free
from the door surface.
2. Continue removing the
gasket by grabbing hold
and gently pulling outward,
exposing the gasket
channel.
3. Remove the 3 pieces of
gasket channel filler.
Gasket With Spacer
Beneath
Gasket Channel
Filler
Plunger
Bracket
21
4. Take out 2 screws and
remove plunger bracket
from gasket channel.
Plunger Bracket
5. Install plunger bracket at the opposite corner, utilizing
the 2 pre-drilled holes.
Plunger
Bracket
6. Install 3 gasket channel filler pieces into the channel.
7. Install gasket, beginning at the corners and then
pressing gasket firmly into the channel on all three
sides.
8. Press down on middle
horizontal portion of
gasket until it adheres
the door surface.
Note: It may be
necessary to apply
a strip of two-sided
tape for a firm
adhesion.
Gasket Channel
to
Press down firmly