Table of Contents
Advertisement
Checking the reference position
Check whether the reference positions of the 1 000 m hand, 100 m hand (compass
hand) and 2.5 m hand are correct.
Checking and correcting the reference position
1
Stop altitude measurement or compass function
and check the power reserve indication.
Charge the watch if the power reserve is lower than "2".
2
Pull the crown out to position .
The hands move to their reference position.
3
Check the reference positions.
Check the reference positions of the hands by referring
to the illustration of the previous page.
If any reference position is incorrect, correct it following
step 3 and after on page 46.
4
Push the crown in to position
procedure.
to finish the
45
Advertisement
Table of Contents
