Checking the reference position
Check whether the reference positions of the water depth hand and maximum
water depth hand are correct.
• Make sure that the watch is not wet before operating the crown or any buttons.
• To unscrew/screw the crown/button, see page 11.
1
Check the power reserve indication.
• Charge if the power reserve level is lower than "2".
2
Pull the crown out to position .
The watch stops and the water depth hand and
maximum water depth hand move to their current
reference positions.
• The power reserve indication hand points to
"READY" after quivering.
Checking and correcting the reference position
Continued on the next page
39