Table of Contents
Advertisement
Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name:
Enter a name for the rule or select an application from the drop-down
menu. Select an application and click << to populate the fields.
IP Address:
Enter the IP address of the computer on your local network that
you want to allow the incoming service to. If your computer is
receiving an IP address automatically from the router (DHCP), you
computer will be listed in the "Computer Name" drop-down menu.
Select your computer and click <<.
Enter the port that you want to open next to Private Port and Public
Private Port/
Port. The private and public ports are usually the same. The public
Public Port:
port is the port seen from the Internet side, and the private port
is the port being used by the application on the computer within
your local network.
Protocol Type:
Select TCP, UDP, or Both from the drop-down menu.
Inbound Filter:
Select Allow All (most common) or a created Inbound filter. You
may create your own inbound filters in the Advanced > Inbound
Filter page.
Schedule:
The schedule of time when the Virtual Server Rule will be enabled.
The schedule may be set to Always, which will allow the particular
service to always be enabled. You can create your own times in the
Tools > Schedules section.
D-Link DIR-614 User Manual
26
Advertisement
Table of Contents
