Norcold DE-560 Owner's Manual page 5

Lower Flange Installation (optional)
The lower flange is required if the refrigerator is to be wall
mounted. Refrigerators installed on the floor do not require this
part.
The lower flange is shipped as a loose part to prevent damage
during shipment. The part is to be attached after the refrigerator
is set into the cut-out opening.
1. Install the lower flange by maneuvering it under and behind
the bottom hinge plate, as shown in Figure 4 (the hinge will
be located on either the right or left side, depending on
door swing preference).
Figure 4
2. Once the lower flange is slipped around the hinge, the part
will swing into place as shown in Figure 5.
3. Secure the flange with screws provided.
Figure 5
Decorative Door Panel Installation
The Norcold refrigerator doors provide slots for inserting deco-
rative panels. Installation of the panels is accomplished by re-
moving the handle assembly, sliding the panel into the frame
slots and reinstalling the handle assembly.
The frame slots are designed to accept panel thickness up to
3/16" maximum.
Table 3
Panel Dimensions
Upper Door
Lower Door
INSTRUCTIONS
1. Prepare panel by cutting to size indicated in accompanying
chart. (See Table 3)
2. Remove handle assembly (A) by removing four screws (B).
(See Figure 6)
3. Slide panel into frame slots.
4. Reinstall handle assembly.
DE-560
19 11/16" X 16"
19 11/16" X 32 1/4"
Figure 6
Figure 7
Instructions for Reversing Door Swing
Your refrigerator is equipped with convertible door hinges. The
hinging of the doors can be changed to the opposite side any-
time you wish.
TOOLS REQUIRED
Phillips Screwdriver - Size # 2
Two Slotted Screwdrivers
REMOVING THE DOORS
1. Turn ON-OFF switch, located on the control panel, to OFF.
Remove all items of food, juices, etc., from the doors. Re-
move the juice rack and storage bins. Close both doors be-
fore removing hinge pins.
2. Remove the top hinge pin using one of the slotted screw-
drivers. Remove the center hinge pin (both pieces) using
the two slotted screwdrivers; one on each end of the pin.
Lastly, remove the bottom hinge pin. Be sure to save the
pins for reassembly later. (See Figure 13)
3. Remove the upper door by opening the door slightly and
pulling the bottom of the door away from the refrigerator.
Allow enough room to slide the door down off of the upper
hinge pin shoulder. (See Figure 8)
4. Remove the lower door by opening it slightly and pulling
the top of the door away from the refrigerator. Allow
enough room so the door can be lifted up and off of the
bottom hinge pin shoulder. (See Figure 9) Be sure to save
the spacer used in the middle hinge bracket, for reassem-
bly later. (See Figures 13A, 13B, and 13C)
Figure 8
5