Table of Contents
Advertisement
7.1 Switch-off timer
Allows you to programme a cooking time for a hotplate
and its automatic switch-off once the set time has
elapsed.
Programming the cooking time
Select the cooking zone and the required power
1.
level.
Touch
.
2.
a The display lights up in the cooking zone.
Use
or to select the cooking time.
3.
a The time begins to count down.
Note: You can automatically set the same cooking time
for all cooking zones. You can find more information
about this under
→ "Basic settings", Page 9.
Changing or deleting the cooking time
Select the cooking zone.
1.
Touch .
2.
8 powerBoost
Allows larger volumes of water to be heated more
quickly than with the power level .
This function is available for all cooking zones if no
other cooking zone is in use.
9 Childproof lock
The hob is equipped with a childproof lock. This pre-
vents children from switching on the hob.
To switch the function on, switch the hob off.
Touch
for four seconds to switch on or off.
10 Basic settings
You can configure the basic settings for your appliance to meet your needs.
10.1 Overview of the basic settings
Display
Setting
Childproof lock
Audible signals
Automatic switch-off of the cooking zones.
Duration of the timer end signal tone
1
Factory setting
To change the cooking time, touch or
3.
to .
7.2 Timer
Enables the activation of a timer of 0–99 minutes. This
function can be used independently of the cooking
zones and other settings. It does not automatically
switch off the hotplates.
Setting the kitchen timer
Select the hotplate and touch
1.
a
beside
lights up.
Use
or
to select the required time.
2.
a The time counts down.
Changing or deleting the timer duration
Touch repeatedly until the display beside
1.
lights up.
To change the cooking time, touch or
2.
to .
Otherwise
and
flash in the power level display.
Press
to switch on or off.
If you want to activate the childproof lock automatically
every time the hob is switched off, you can find further
information under Basic settings → Page 9.
Value
1
- Manual.
Automatic.
– Switched off.
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
– switched off.
-
- minutes until the appliance switches off auto-
matically.
1
– 10 seconds
– 30 seconds
- 1 minute
powerBoost en
or set it
twice.
or set it
1
.
9
Advertisement
Table of Contents
