Removal And Installation Of The Bucket - Komatsu Avance WA500-3 Operation & Maintenance Manual

OPERATION

REMOVAL AND INSTALLATION OF THE BUCKET

When pins are knocked in with a hammer, pieces of metal may fly and cause serious injury.
When carrying out this operation, always wear goggles, hard hat, gloves, and other protective equipment.
When the bucket is removed, place it in a stable condition.
If pins are hit with a strong force, there is a hazard that the pin may fly out and injure people in the surrounding area. Make sure
that there is no one in the surrounding area before starting the operation.
When removing the pins, do not stand behind the bucket. In addition, be extremely careful not to put your foot under the bucket
while standing at the side for the work.
When removing or inserting pins, be extremely careful not to get your fingers caught.
Never insert your fingers into the pin holes when aligning the holes.
Remove or install the bucket in the following manner, if so required for the convenience of transportation.
REMOVING THE BUCKET
1. Remove mounting bolt (1).
2. Sling the bucket link, then pull out bucket link pin (2).
Secure the bucket link to the tilt lever with wires.
3. Remove mounting bolt (3).
WARNING
OPERATION
3 - 73