Step 3: Unpacking, Moving And Placing The Range - Thermador PRG304EG Installation Instructions Manual

Step 3: Unpacking, Moving and Placing the Range

CAUTION
Proper equipment and ad-
equate manpower must be
used in moving the range to
avoid injury, and to avoid
damage to the unit or the
floor. The unit is heavy
and should be handled
accordingly.
• The range has an approximate
shipping weight as shown in
Chart A. The grates, griddle
plate and frame, burner caps,
front kick panel and oven racks
must be removed to facilitate
handling. This will reduce the
weight as shown in Chart A and
allow the range to pass through
30" doorways. See Figs. 2A
and 2B on Page 5. Do not
remove the grill or griddle
assemblies.
• Remove the outer carton and
packing material from the ship-
ping base. The all gas ranges
are held to the skid by four (4)
bolts (see Fig. 4 and 5). After
removing the bolts the range
must be lifted and removed from
the skid.
• IMPORTANT: Do not lift the
range by the oven door's
handle, as this may damage
the door hinges and cause
the door to fit incorrectly to
the oven cavity.
NOTE: Leave adhesive-backed
foam layer over brushed-metal
surfaces to protect finish from
scratches, until the range is in-
stalled in final position.
Chart A
Shipping Weight
Weight without
packing materials
Without door(s),
burner caps, front kick
panel and oven racks
FIG. 4 – Removal of Two Front
Shipping Bolts
8
30" Range 36" Range
335 lbs. 444 lbs.
285 lbs. 390 lbs.
215 lbs. 295 lbs.
FIG. 5 – Removal of Two Rear
Shipping Bolts
Left Rear
®
Shipping
Bolt
48" Range
584 lbs.
524 lbs.
395 lbs.