Samsung S49A95 U Series User Manual page 33

2nd 3rd
Input Port Ver.
Auto Source Switch
Key Repeat Time
Power LED On
Description
Select an HDMI version.
• 1.4 / 2.0
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If the
HDMI Mode is set to 2.0, HDR On is available only in UHD 60 Hz. In a higher resolution (UHD 120/140), HDR On is unavailable due to the bandwidth
limitation.
― If you set the
HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― If you set the
HDMI Mode to 2.0, some high resolutions may not be supported because of bandwidth limitation of the HDMI 2.0 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
― Set
HDMI Mode to 1.4 if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
― Set
HDMI Mode to 2.0, if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
No Repeat is selected, a command responds only once when a button is pressed.
33