Troubleshooting - Nikon N60 Instruction Manual

Troubleshootin
FE E
blinks
FE
E blinks
• Lens is not set to its
• Set lens to
16
minimum aperture. minimum aperture.
• Batteries are
• Have fresh ones
~appears
nearing
ready.
15
exhaustion .
• Turn the power off
~blinks
• Batteries are just and replace
15
about exhausted. batteries with new
ones.
F - -
blinks
F- -
blinks
• Attach CPU lens
• Non-CPU lens is
(except IX-Nikkor)
(F - -
appears
(F - -
appears
attached or lens is
correctly. (Or set 16
without blinking
without blinking
not attached .
the exposure
in M mode) in M mode)
mode to Manual.)
E,-r
and
Q
blink
• Film is not
Ero-
blinks
correctly
• Reload film .
19
and E appears
positioned.
Q
blinks
• Non-OX-coded
• Load OX-coded
19
and E appears film is loaded.
film .
• An exposed film
• Remove film
Q
blinks remains in the film
cartridge.
27
cartridge chamber.
• Turn the power off
• Battery power is
and replace
E ,- ,- and
Q
blink
low or temperature batteries with new
35
is too low to
ones. Then, turn
rewind film .
the power on and
rewind film again.
In certain cases , due to static electricity or poorly loaded batteries, the
N60/ N60QO camera's microcomputer may turn the camera off, even with fresh
properly installed batteries. For the same reason, film may not advance properly.
In each of these cases, to resume operation , simply turn the power off, then turn
it on again, or remove batteries and install them again.
70