Figure 79. Disconnect LCD cable connected to the system board
Step 4.
Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove nine screws and then remove the LCD unit.
Figure 80. Remove nine screws and remove the LCD unit
Screw specifications
M2.5 x L6
M2 x L5
Remove the upper case
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 60
"Remove the battery pack" on page 61
"Remove the solid-state drive (SSD) module" on page 62
"Remove the Wi-Fi card" on page 64
Number of screws
6
3
.
Chapter 4
Removing a FRU or CRU
77