Stealth Cam STC- ZX36NG Instruction Manual page 13

o
PIR VIDEO: In this mode the camera will take a video clip at a designated resolution for a
designated length with a designated time out when the camera senses activity in front of the
unit. This mode is available for both day and night activities.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time
that the camera will wait before it reinitializes its PIR sensor for the next activation. With the
TL mode this setting is only active if TL Delay is set to 1 min or greater. This setting can be
changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking,
use of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to
59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to
the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00).
"
VIDEO RES – 720 x 480 (default): This setting is used to determine the resolution of each
video taken by the camera. With this option blinking, use the UP or DOWN arrow key to
move between the options of: 720 x 480 or 1280 x 720. The higher the resolution of a video
the more space the file will take on the SD memory card.
"
VIDEO LENGTH – 010 S (default): This setting is used to determine the length of time, in
seconds, of the video recording. This setting can be changed between the numbers of 5 to
180. With this option blinking, use the UP or DOWN arrow key to move between the value
range in increments of 5. The maximum night video is 30 seconds to conserve the batteries.
"
VIDEO AUDIO – ON (default): This setting is used to determine if the camera should record
audio (sound) with its video recording. With this option blinking, pressing the UP or DOWN
arrow buttons will cause the camera to cycle between the two options of ON or OFF.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
13