Stealth Cam STC- ZX36NG Instruction Manual page 11

!
TIME FORMAT – 12 HOUR (default): This setting is used to tell camera if the time
programmed and displayed on the Info Bar should be in the basic 12 hour (AM/PM) format
or the 24 hour (military) format. With this option blinking, pressing the UP or DOWN arrow
buttons will cause the camera to cycle between the two options. NOTE: Should the format
be changed to 24 hour, the previous SETUP TIME will now be adjusted as such and remove
the AM/PM part of the time.
!
MODE – This setting is used to tell the camera how it should take its images. The camera is
equipped with TRIAD Technology, allowing for 3 different options to be selected by the user.
With this option blinking, use the UP or DOWN arrow key to move between the options of:
PIR PHOTO, PIR VIDEO, or TIME LAPSE. Based upon the selection chosen the menus for the
camera will change.
o
OPERATING HOURS: This new function allows you to choose when you'd like the
camera to be active and working. By pressing the ENTER button and choosing between
the two options below and pressing Enter again, you will save your selection.
"
24/7 (default): This puts the camera in normal 24/7 working mode.
"
SCHEDULED: This allows you to tell the camera what time range it should be operational and
not to be operational.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
-­‐ START TIME (HH:MM): Start time you want the camera to be active.
-­‐ STOP TIME (HH:MM): End time you want the camera to be non-­‐active.
Page
11